The machine is in good technical condition, connected to power, possible to test. CNC system Siemens S 810 D. SBL 500 CNC is a lathe with a slant bed, designed for machining flange components clamped in overhang, but primarily for shaft components supported by the tailstock. In the configuration with a tool turret with driven tools, off-axis machining is also possible. ▪ The machine base consists of a column with a triangular cross-section. ▪ The rolling guideways are fully protected by sliding and telescopic covers. The headstock is of rigid construction, without gear stages. ▪ The cross slide moves along the "X" and "Z" axes by means of ball screws. Workpiece clamping is performed by a hydraulically operated chuck. The tailstock has a hydraulically extendable quill. ▪ The machine is equipped with lubrication, lighting and coolant systems. Chip collection is alternatively either by a chip tray or a chip conveyor. ▪ The machine concept complies with EU requirements and regulations. ▪ The control system used – SINUMERIK 810D or FAGOR 8055TC – enables full-featured machine control. ▪ The compact control system panel features a TFT colour display. ▪ The part machining program can be created from the control system panel with full 2D graphics support, with the possibility of programming using cycles and DIN, in parallel with machine operation according to another program. ▪ For better serviceability, the control system and drives are from a single manufacturer. ▪ The spindle drive is ensured by a fully controlled vector drive with an AC motor, with the possibility of using the C axis, providing machining at constant cutting speed. ▪ High-dimensioned AC servo motors and ball screws enable dimensionally accurate feeds. ▪ Oriented spindle stop. ▪ Machine accuracy according to STN ISO 1708 (DIN 8605). ▪ Digital display of spindle speed and slide feed rate.